Improved linking for Adaptive Clearing when using slot opening.Improved linking for Adaptive Clearing to avoid retracts.Fixed the issue where for a grooving operation, when "allow rapid retract" was enabled with pecking, each peck was not rapiding during the retract move after each peck.Fixed the issue for Turning: Profile finishing passes where leads were not generated at an angle with respect to the toolpath direction when "Use Fixed Lead Direction" was turned off #9944.Fixed the issue where an inside single groove was starting and ending at the center line instead of honoring the retract and clearance cylinders #10068.Added a new option "Selected Position(s)" for single groove operation radii parameters to allow the user to either cut to the X position of the selected position or the inner radius for outside grooving and outer radius for inside grooving.Fixed issue where for single groove and part toolpaths, if the final peck ended exactly at the total depth of cut, an additional superfluous peck was created.Fixed an issue with turning Profile operations where if the "Use Fixed Lead Direction" parameter was turned off, the leads created were not at an angle with respect to the direction of the toolpath #10284.Fixed a particular case of single groove where the ID groove was starting and ending at the Z axis instead of the clearance plane #10422. Fixed a bug with a particular single groove case where an ID groove was not cutting upto the outer radius #10423.Fixed the issue where an inside threading operation in turning was allowed to end at the final toolpath Z position (unsafe) instead of at the safe Z position #10386.Fixed an issue where a Turning Part operation was not generating the correct toolpath when edge break was turned on and a round grooving tool was used #10672.Fixed an issue where expressions did not persist in the Chuck Offset field in a turning / mill turn setup dialog #10694.Fixed potentially wrong initial tool axis for multi-axis toolpath for stock simulation.Updated simulation to avoid some annoying false reports of collisions for multi-axis toolpath.Improved radius compensation for 2D Profile operations in various examples #9736.Removed unused 'fineStepdown' parameter from 3d Contour & 3d Pocket operations #10291.Added turret column to tool library #10554.Added the ability to set the Safe Z in the setup dialog with reference to the WCS origin, stock front or stock back #8661.Added the ability to override the Safe Z from the setup dialog in each turning operation and specify an approach and retract point #10199.Added the ability to round sharp corners in a parting toolpath, specifically when edge break with a chamfer is enabled.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |